欢迎到:淄博金冠厨房设备有限公司

全国热线:400-0533-137

新闻
首页 > 新闻 > 内容
排烟罩的维护
编辑:淄博金冠厨房设备有限公司   时间:2017-11-07

排烟罩在日常运用中经常会出现各种缺点和事端,因而在日常运用中要增强消防排烟风机的保护,包含定期肃清消防排烟风机及气体保送管道内部的尘埃、污垢防止锈蚀.

Exhaust fan fire will often present various problems and accidents in daily use, so in everyday use to enhance the maintenance of the exhaust fan fire, including dust, regular internal purge exhaust fan fire and gas transport pipeline dirt to avoid corrosion.

消防排烟风机在正常工作中要特别留意如发现流量过大,不契合运用恳求,或短时间内需求较小的流量,可应用节省装置停止调理。

Fire smoke exhaust fan in the normal operation should pay special attention to, such as the discovery of flow is too large, do not meet the application request, or short time demand less flow, can use throttling installation, stop conditioning.

1、查看与转换各接合面间的垫片和密封填料。

1. Check and change the gasket and seal between the joints.

2、堵截主电源,做好相应的标明,查看电机接地线能否杰出。

2, cut off the main power supply, do the corresponding marking, check whether the motor grounding wire is good.

3、清洁电机及风轮、过滤器及机壳内部。

3 、 clean motor and wind wheel, filter and inside of casing.

4、排烟罩查看各局部螺丝及联轴,并紧固好。

4, check the local screws and shafts, and fasten.

5、向滚动部位填加适量的光滑油,以保证联轴节及轴承的灵敏性及稳定性。

5 fill the rotating parts with proper amount of smooth oil to ensure the sensitivity and stability of the couplings and bearings.

6、检测电动机的绝缘电阻能否契合规矩,查看主回路触点。若触头严峻烧蚀(触头点磨损至原厚度的三分之一),应转换触头。

6. Check whether the insulation resistance of the motor fits the rules and check the main circuit contacts. If the contact is severely ablated (1/3 of the contact point is worn to the original thickness), the contact shall be changed.

7、调整皮带的松紧度 消防排烟风机,用手盘动风轮,察看滚动有无晃动。

7, adjust the tightness of the belt, fire smoke exhaust fan, use the hand wheel to move the wind wheel, see whether the rotation or not.

8、查看排烟罩调理阀机械开闭动作能否牢靠、灵敏,开闭视点标志清楚。

8, check the mechanical valve opening and closing action can be firm and sensitive, open and close angle mark clear.